FAUCET EXTENDER · 1080° SWIVEL

Aim The Water Anywhere

Three turning joints lift the stream up and over the basin, so you can rinse your face, fill a tall pot or reach the far corner without cupping your hands.

Two spray modes · Three thread adapters · Fits most basin and kitchen taps

WHY IT HELPS

A Low Spout Makes Everything Awkward

Most basin taps sit short and close to the back edge, so you lean in to rinse and the water runs down your wrist instead of into the sink. This extender moves the outlet out and up, and lets you point it where you need it.

01 / THE EVERYDAY WIN

Wash Without Bending Low

Children, grandparents and anyone with long hair knows the problem: the spout sits too low and too far back, so you lean in and the water lands short. The extender adds 140 mm of reach and lets you angle the head down or out, so the water comes to you.

02 / THE SWIVEL

Three Joints, 1080° Of Travel

The collar at the tap turns a full circle. The arm turns a full circle on its own pivot. The head turns a full circle again — three circles, which is where the 1080° figure comes from. Set the angle once and it stays where you leave it.

03 / FITTING

Which Thread Is On Your Tap?

Three sizes cover the taps this extender is made for. A 22 mm female thread takes the extender directly. A 24 mm male thread screws into the collar. The G1/2 adapter steps a 20 mm coarse shower-type thread up to the same fit.

04 / THE BUILD

Copper Body, Four Plated Layers

Under the shine there is a copper base, then a copper-chrome layer, bright nickel and finally the chrome top coat. That stack is why the finish holds up to daily tap water, and why the unit does not feel like hollow plastic in the hand. Two O-rings sit inside the joints to keep them dry.

05 / SIZE

95 × 140 × 22 mm, 60 g

Short enough to sit quietly beside the tap, long enough to clear the basin rim. The head is 22 mm across — about the width of a bottle cap — and the whole unit weighs 60 g, so it does not pull a light tap off balance.

PRODUCT DETAILS

The Measured Numbers

Every figure below is taken from the unit itself, not from a size chart.

GET STARTED

How to Use

1. Turn off the tap and unscrew the old aerator anticlockwise.
2. Match the thread: 22 mm female, 24 mm male, or the G1/2 adapter for 20 mm.
3. Screw the extender on by hand, then a gentle final turn — no wrench, it will mark the chrome.
4. Open the tap slowly, check the joints for drips, then set the head at the angle you want.

FEEDBACK

What Buyers Say

Notes from recent orders in Kenya and Ghana.

IN THE BOX

PACKAGE INCLUDES

1 × Swivel faucet extender with dual-mode head
1 × 22 mm female thread adapter
1 × 24 mm male thread adapter
1 × G1/2 (20 mm) adapter

CASH ON DELIVERY

Screw It On. Done.

Water where you need it, from the first evening. Pay the courier when it reaches your door.

SHOP WITH CONFIDENCE

WHY CHOOSE US?

Carefully selected products, clear communication, and support you can reach by phone or WhatsApp. Order today with Free Shipping and Cash on Delivery.